rj45esdlayoutguidelines

ThemainreasonisthattheEthernetcablecouldbeinstalledoutsideduetothelayoutrequirements.Whenthundering,theoutsidecableiseasiertosense ...,2009年12月11日—TomaximizeESDperformance,thedesignershouldconsiderselectingadiscretetransformerasopposedtoanintegratedmagnetic/RJ45module.,2016年2月16日—•USBLayoutGuidelinesonpage5.•EthernetLayoutGuidelineson...TomaximizeESDperformance,thedesignershouldconsiders...

參考資訊如下
10G Ethernet ESDEOS Protection Solution

The main reason is that the Ethernet cable could be installed outside due to the layout requirements. When thundering, the outside cable is easier to sense ...

AN 20.14

2009年12月11日 — To maximize ESD performance, the designer should consider selecting a discrete transformer as opposed to an integrated magnetic/RJ45 module.

AN2054

2016年2月16日 — • USB Layout Guidelines on page 5. • Ethernet Layout Guidelines on ... To maximize ESD performance, the designer should consider selecting an RJ45 ...

Electrostatic Discharge (ESD) Protection Design Guide

Choosing the most appropriate suppressor technology requires a balance between equipment protection needs and operating requirements, taking into account ...

ESD Protection Layout Guide (Rev. A)

ESD selection guides are available in Technical Documents at www.ti.com/esd for guidance in choosing the correct type of TVS diode for a particular system. With ...

Ethernet ESD layout

2023年4月11日 — I need help in the layout of an ethernet interface (ESD protections + RJ45 connector). The connector I would like to use already has built ...

Ethernet Layout Routing Guidelines and Standards

2019年7月1日 — Table of Contents. High-level Ethernet Layout, Routing, and Architecture; Ethernet PCB Routing; Routing From the Controller IC/PHY; Routing and ...

Ethernet PHY PCB Design Layout Checklist

The following app note covers the fundamentals and general guidelines for ESD device layout: . This next following app note covers Ethernet-specific ESD ...

i.MX28 Layout and Design Guidelines

— If using a discrete magnetics module, a ground plane must not be placed under the magnetics, the RJ45 connector, or the area between the magnetics and RJ45 ...